Toshiba TLCS-90 Series Data Book page 126

TOSHIBA THP8048PI, TMP8035PI
The interrupt system is single level in that once an interrupt is detected
all further interrupt requests are ignored until execution of an RETR
(which should occur at the end of an interrupt service routine) reenables
the interrupt input logic.
· An interrupt sequence is initiated by applying a low level "0" to the I1\T
pin.
INT
is level triggered and active low "'ihich allows "Wire Oring" of
sever~l
interrupt sources. The interrupt level is sampled every machine
cycle during
ALE
and when detected causes a "jump to subroutine" at Loca-
tion 3.
As in any call to subroutine, the Program Counter and Program
Status Word are saved in the stack.
· When an overflow occurs in the internal timer/event counter an interrupt
request is generated which is reserviced as outlined in previous paragraph
except that a jump to Location
7
is used instead of
~
If
INT
and times
overflow occur simultaneously then external request
I~~
takes precedence.
• If an extra external interrupt is needed in addition to
I~~
this can be
achieved by enabling the counter interrupt, loading FFH in the counter
(one less than the terminal count), and enabling the event counter mode.
A
"I"
to
"0"
transition on Tl will cause an interrupt vector to Location
7.
The
i~terru?t
service routine pointed to
De
ad~resses ~~
Location
5
or
1:-.;5:
reside in oe=:ry be:"'::7:.
a
and
20~7,
i:€"
E~~:
O.
Figure 3 illustrates the concept of the interrupt control circuit.
(6) Stack (stack Pointer)
• An interrupt or Call to subroutine causes the contents of the program
counter to be stored in one of the 8 register pairs of the Program Counter
Stack. The pair to be used is determined by a 3-bit stack pointer which is
part of the Program Status Words (PSW explained in section
(8».
Data
RA~
locations, 8 through 23 are available as stack registers and are used to
store the program counter and 4-bits of PSW as shown in the figure.
• The stack pointer when initialized points to
RAM
location
8
and
9.
The
first subroutine jump or interrupt results in the program counter contents
being transferred to Locations 8 and 9. Then the stack pointer is incre-
mented by one to point to Locations 10 and 11. Eight levels of subroutine
are obviously possible.
• At the end of a subroutine signalled by a RET or RETR causes the stack
pointer to be decremented by one and the contents of the resulting pair
to be transferred to the Program Counter.
MCU48-116