Kenwood NX-5000 Series Function Reference page 126

2 COMMUNICATIONS IN AN EMERGENCY
2.8 Placing the Transceiver in Emergency Mode Using the Lone Worker Function
0
Exiting Lone Worker Mode
1
Do either of the following operations while the transceiver is in Lone Worker Mode:
0 Press the Lone Worker key.
0
Select a channel where Lone Worker is disabled.
0
Press the Menu key to enter Menu Mode, and select "Lone Worker" and then select "OFF".
0
The " " icon disappears and the transceiver exits Lone Worker Mode.
The Key Beep B (2 beeps) sounds from the transceiver when the Lone
Worker key is pressed.
Note
If "Transmit/Receive Inhibit" is configured in Lone Worker Type, Lone Worker cannot be turned ON or OFF in Menu
0
Mode. (Refer to Lone Worker
Lone Worker cannot be activated while the transceiver is in the Stun state or while in Transceiver Password Mode.
0
For Mobile, if the AUX Input port to which "Emergency" is assigned becomes active for the time configured in Emergency
0
Delay Time while the transceiver is in Lone Worker Mode, the transceiver enters Emergency Mode.
Lone Worker can be activated even if the Key Lock state is activated while the transceiver is in Lone Worker Mode.
0
If the transceiver migrates from Lone Worker Mode to Emergency Mode, the transceiver exits Emergency Mode if the
0
Emergency key is pressed for a length of time greater than the length of time configured in Hold Delay.
If a scan initiates while the transceiver is in Lone Worker Mode, the scan initiates with Lone Worker Mode enabled. If the
0
scan starts while the transceiver is in a mode other than Lone Worker mode, the scan starts with Lone Worker Mode
disabled.
Configuration using KPG-D1/ D1N
0
Assigning functions to the PF keys on the transceiver (
0
Configuring Lone Worker (DMR Conventional) to be enabled or disabled (Personality) (
> Personal > Personality > DMR Conventional > General)
0
Configuring Lone Worker (DMR Conventional) to be enabled or disabled (Channel Edit) (
> Zone/Channel > Channel Edit > DMR Conventional > General)
DMR FUNC (K, F)/Ver 2.20
Emergency Mode
Duration of Lone
Worker Tone
Lone Worker
Interval
Transmit (PTT)
Figure 2-2 Lone Worker Mode
Type.)
Sounds the
Lone Worker Tone
Time
AUX Port (except
External PTT (Voice)) (Mobile only)
PC Command
Transceiver Settings > Key Assignment)
CONTENTS
A
12 : 34
M
Z o n e 1
C h a n n e l 1
M en u Zo ne+
Transceiver Settings
Transceiver Settings
109
INDEX