Kenwood NX-5000 Series Function Reference page 57

1 DMR CONVENTIONAL SYSTEM
1.10 Sending and Receiving a Status Message (Status Call)
Sending a Status Message
This section describes how to send a Status Message in Status Mode.
The transceiver enters Status Mode with one of the following operations, and then the transceiver will send a Status
Message.
0
Status, Individual + Status, or Group + Status key
Pressing the Status key places the transceiver in Status Mode. In this case, a Status Message is addressed to a Base
ID.
Or, pressing the Individual + Status or Group + Status key places the transceiver in Individual Call Mode or Group Call
Mode. The transceiver enters Status Mode by pressing the [F] key after selecting the target Unit ID or Group ID.
0
Menu key
Pressing the Menu key places the transceiver in Menu Mode, and then the transceiver enters Status Mode by selecting
"Status". In this case, a Status Message is addressed to a Base ID.
Or, if "Individual + Status" or "Group + Status" is selected after entering Menu Mode by pressing the Menu key, the
transceiver enters Individual Call Mode or Group Call Mode. The transceiver enters Status Mode by pressing the [F]
key after selecting the target Unit ID or Group ID. (Refer to Common FUNC
0
Keypad entry
If "Status" is configured for Keypad Operation, pressing the [0] to [9] keys on the transceiver keypad causes the
transceiver to enter Status Mode. In this case, a Status Message is addressed to a Base ID.
If "Individual + Status" or "Group + Status" is configured in Keypad Operation, pressing the [0] to [9] keys on the keypad
also places the transceiver in Individual Call Mode or Group Call Mode. The transceiver enters Status Mode by pressing
the [F] key after selecting the target Unit ID or Group ID. (Refer to Common FUNC
Note
For operating in Individual Call Mode or Group Call Mode, refer to the information on the various call types of DMR.
Operating the transceiver
0
Sending a Status Message by list selection
1
Select one of the following operations to place the transceiver in Status Mode.
0
Press the Status key.
The transceiver enters Status Mode. In this case, a Status Message is
addressed to a Base ID.
0
Press the Individual + Status key.
Pressing the [F] key after selecting the Unit ID of the target transceiver
causes Status Mode to be entered.
0 Press the Group + Status key.
Pressing the [F] key after selecting the Group ID of the target
transceiver causes Status Mode to be entered.
Or, the transceiver enters Status Mode by pressing the Menu key or using
a keypad. In this case, the following operations are identical.
DMR FUNC (K, F)/Ver 2.20
Using Menu Mode.)
Keypad Operation.)
Status
In Service
Call Office
Call Home
Se nd
CONTENTS INDEX
A
12 : 34
M
001
Bac k
40