Kenwood NX-5000 Series Function Reference page 176

5 DATA COMMUNICATION FUNCTIONS
5.2 Restricting the Warning Display during Data Communications (Silent Report)
5.2 Restricting the Warning Display during Data Communications
(Silent Report)
Silent Report is the function to configure whether the transceiver transmits in standby display state without emitting the
Alert Tone and flashing or lighting the LED, when sending and receiving the status and GPS data.
This function is used to keep a user from noticing the data communication request from a base station and GPS data
transmission.
If this function is enabled, the LCD display, the LED display, and emitting the Alert Tone during data communications can
be restricted as follows:
0 The display during data communications (such as "Send Data", "Complete", "Busy", and "No Reply") is not displayed.
0
The LED does not light or flash during data transmission.
0
The Alert Tone, Control Tone, or Warning Tone is not emitted.
This function can be used for the following communications in a DMR Conventional system:
0 AUX Input Status Message transmission
0
Status transmission on receipt of Status Request
0
Automatic GPS data transmission
0
GPS transmission by GPS Polling reception
Note
Silent Report is not applied when the transceiver receives a Status Request or receives GPS Polling.
Configuration using KPG-D1/ D1N
Configuring Silent Report to be enabled or disabled (
1 > Others)
DMR FUNC (K, F)/Ver 2.20
Transceiver Settings > Optional Features > Optional Features
CONTENTS
159
INDEX