Kenwood NX-5000 Series Function Reference page 94

1 DMR CONVENTIONAL SYSTEM
1.18 Remote Operation by Radio Communication (Remote Control)
5
Press the [ ] or [
Stun:: A Remote Stun message is sent.
Revive:: A Remote Revive message is sent.
Kill:: A Remote Kill message is sent.
Monitor:: A Remote Monitor message is sent.
Radio Check: A Radio Check message is sent.
6
Press the PTT switch, the
The selected Remote Control message is sent.
"Complete" appears if the Remote Control message is properly sent to the
target transceiver.
Note
If the Remote Control Mode previously used is Manual Dialing mode, the transceiver enters Manual Dialing mode by
0
pressing the Remote Control key. A selection screen for the Individual ID List will appear by pressing the Function [W]
key.
If no ID is registered in the Individual ID List, the transceiver enters Manual Dialing mode by pressing the Remote
0
Control key if Manual Dialing is enabled. In this case, the transceiver cannot enter Remote Control Mode if Manual
Dialing is disabled.
Configuration using KPG-D1/ D1N
0
Assigning functions to the PF keys on the transceiver (
0
Configuring Manual Dialing to be enabled or disabled (
DMR Conventional > DMR)
DMR FUNC (K, F)/Ver 2.20
] key to select the Remote Control message to send.
Menu ([ ]) key, or the [ ] key.
Transceiver Settings > Key Assignment)
Transceiver Settings > Personal > Personal Features >
CONTENTS
A
12 : 34
M
Remote Control 5
Kill
Monitor
Radio Check
Se nd Bac k
A
12 : 34
M
Zone 1
Channel 1
S e n d D a t e
M en u Zo ne+
A
12 : 34
M
Zone 1
Channel 1
C o m p l e t e
M en u Zo ne+
77
INDEX