Kenwood NX-5000 Series Function Reference page 49

1 DMR CONVENTIONAL SYSTEM
1.7 Making a Group Call
Note
If Busy LED is enabled, the LED lights green when the transceiver is receiving. (Refer to Common FUNC
0
If Alert Tone is configured to sound when receiving, an Alert Tone will sound. (Refer to
0
receiving a Group Call.)
If Selective Call Alert LED or Optional Signaling LED is enabled, the LED flashes when the transceiver is receiving.
0
(Refer to Transceiver behavior when receiving a Group
The transceiver can record the receipt of a Group Call. The record can be checked in Stack Mode. (Refer to Common
0
FUNC Viewing the Receive History
If Group ID Scan (DMR) is enabled, the transceiver is on standby to receive a Group Call from all Group IDs configured
0
in the Group ID List. (Refer to
The transceiver can send the ID of the transmitting transceiver from the communication port on the transceiver when
0
receiving a Group Call. (Refer to
Transceiver behavior when receiving a Group Call
0
Alert Tone
If the received Group ID is configured in the Group ID List, an Alert Tone sounds from the transceiver according to the
configuration for Alert Tone of the corresponding Group ID.
However, if "Common" is configured for Alert Tone in the Group ID List, or if the received Group ID is not configured in
the Group ID List, an Alert Tone sounds from the transceiver according to the configuration for Alert Tone (Group
Call) used in common in a DMR Conventional system.
0
Selective Call Alert LED
If the received Group ID is configured in the Group ID List, the LED blinks according to the configuration for Alert LED
Color of the corresponding Group ID.
However, if "Common" is configured for Alert LED Color of the Group ID List, or if the received Group ID is not configured
in the Group ID List, the LED blinks according to the configuration in Alert LED Color (Group Call) used in common in
a DMR Conventional system.
0
Optional Signaling LED
If Optional Signaling LED is enabled, the LED flashes in yellow. However, when Selective Call Alert LED is enabled,
LED will flash in accordance with the configuration of Selective Call Alert LED.
Also, when the transceiver key is operated while the LED flashes according to the Selective Call Alert LED configuration,
the LED flashes in yellow if the matching state of Optional Signaling persists.
Configuration using KPG-D1/ D1N
0
Configuring Selective Call Alert LED to be enabled or disabled (
> Conventional)
0
Configuring Optional Signaling LED to be enabled or disabled (
> Conventional)
0
Configuring Alert Tone/ Alert LED Color (Group ID List) (
0
Configuring Alert Tone (Group Call) used in common in a DMR Conventional system (
DMR > DMR Information > Conventional > Alert Tone)
0
Configuring Alert LED Color (Group Call) used in common in a DMR Conventional system (
> DMR > DMR Information > Conventional > Alert LED Color)
DMR FUNC (K, F)/Ver 2.20
Call.)
(Stack).)
Group ID Scan (DMR).)
Sending the Received Unit ID from the Communication Port (Unit ID Serial
Transceiver behavior when
Transceiver Settings > DMR > DMR Information
Transceiver Settings > DMR > DMR Information
Transceiver Settings > DMR > Group ID List)
CONTENTS
Busy LED.)
Output).)
Transceiver Settings >
Transceiver Settings
32
INDEX