Kenwood NX-5000 Series Function Reference page 66

1 DMR CONVENTIONAL SYSTEM
1.10 Sending and Receiving a Status Message (Status Call)
AUX Input Status Message (Mobile Only)
Supported Models: Mobile
AUX Input Status Message is the function that sends out a specified Status Message when the AUX Input port goes high
level to low level or goes low level to high level.
A Status Message can be sent out when there is a change in the AUX Input port status by attaching a sensor to the port.
The target transceiver is the ID configured in Base ID. (Refer to
To use this function, AUX Input Status Message must be assigned to one of AUX Input ports.
Configuration using KPG-D1/ D1N
0
Configuring AUX Input Status Message (
AUX Input Status Message)
0
Assigning functions to the AUX Input port (
AUX Output Status Message (Mobile Only)
Supported Models: Mobile
AUX Output Status Message is the function to switch the status of the AUX Output port from high to low or from low to
high when the transceiver receives the specified Status Message. This function can be used to remotely turn the external
device on or off.
To use this function, AUX Output Status Message must be assigned to one of AUX Output ports.
Configuration using KPG-D1/ D1N
0
Configuring AUX Output Status Message (
AUX Output Status Message)
0
Assigning functions to the AUX Output port (
DMR FUNC (K, F)/Ver 2.20
Base ID.)
Transceiver Settings > DMR > DMR Information > Conventional >
Transceiver Settings > Extended Function > AUX)
Transceiver Settings > DMR > DMR Information > Conventional >
Transceiver Settings > Extended Function > AUX)
CONTENTS INDEX
49