Kenwood NX-5000 Series Function Reference page 84

1 DMR CONVENTIONAL SYSTEM
1.15 Sending GPS Data
Sending GPS Data According to the Request from the Base Station (GPS Report
Mode)
GPS Report Mode allows the transceiver to automatically send GPS data when a GPS data transmission request is received
from the base station.
This function is used when the base station controls the timing to require GPS data. This function is also used to avoid a
data collision if there are many transceivers.
To use this function, "Poll" must be configured for GPS Report Mode by using KPG-D1/ D1N.
Note
The transceiver sends GPS data to the ID configured for GPS Base ID or Base ID, not to the ID that sent the data
transmission request. However, if GPS Report Back to Requested ID is enabled, GPS data is sent to the ID that sent
the data transmission request. (Refer to
Configuration using KPG-D1/ D1N
Configuring GPS Report Mode (
Sending GPS Data Manually by Using a Key (Send the GPS Data)
GPS data can be sent manually by a user pressing the Send the GPS Data key. Or, pressing the Menu key causes the
transceiver to enter Menu Mode, and then the GPS data can be sent manually by selecting the "Send the GPS Data". (Refer
to Common FUNC Using Menu
Configuration using KPG-D1/ D1N
Assigning functions to the PF keys on the transceiver (
Sending GPS Data Based On Travel Distance (GPS Distance Change)
GPS Distance Change allows the transceiver to send GPS data when the distance between the location of the previous
GPS data transmission and the current location exceeds the value configured in Distance Value.
The transceiver calculates the distance between the position where the GPS data was sent and the current position at
regular time intervals (3 sec) after the transceiver automatically or manually sent GPS data. The GPS data is sent if the
calculated distance exceeds the value configured for Distance Value. If no GPS data is sent after the transceiver is turned
on, the transceiver regards the location information first received from the GPS unit as the previous transmission position
and calculates the distance to the current position. The distance is calculated from the latitudinal and longitudinal values.
Configuration using KPG-D1/ D1N
0
Configuring GPS Distance Change to be enabled or disabled (
Features > DMR Conventional > GPS > GPS Distance Change)
0
Configuring Distance Value (
> GPS Distance Change)
DMR FUNC (K, F)/Ver 2.20
GPS Report Back to Requested
Transceiver Settings > Personal > Personal Features > DMR Conventional > GPS)
Mode.)
Transceiver Settings > Personal > Personal Features > DMR Conventional > GPS
ID.)
Transceiver Settings > Key Assignment)
Transceiver Settings > Personal > Personal
CONTENTS
67
INDEX