Kenwood NX-5000 Series Function Reference page 42

1 DMR CONVENTIONAL SYSTEM
1.6 Initiating an Individual Call After Ensuring That the Target Party Is Available for Communications (Individual Call Acknowledge Request)
1.6 Initiating an Individual Call After Ensuring That the Target
Party Is Available for Communications (Individual Call
Acknowledge Request)
Individual Call Acknowledge Request is the function that allows a user to distinguish whether or not the receiving
transceiver is available to communicate so as to initiate an Individual Call in a DMR Conventional system.
Individual Call Acknowledge Request enables a call to the particular transceiver having the specified Unit ID in the same
way as a normal Individual Call; however, an acknowledgment message must be received from the receiving transceiver
for the communication to start (also, receiving an Individual Call from the receiving transceiver allows the communication
to start).
The transmitting transceiver sends a message requesting an acknowledgment when initiating an Individual Call. Upon
receipt of the message requesting an acknowledgment, the receiving transceiver sends to the transmitting transceiver an
acknowledgment message to notify that the receiving transceiver is available for the call. The transmitting transceiver
becomes enabled for the communication upon receipt of the acknowledgment message from the receiving transceiver.
To use this function, Individual Call Acknowledge Request needs to be enabled and a value other than "No" needs to be
configured in Busy Channel Lockout (DMR) by using KPG-D1/ D1N for the channel to be used by the transmitting
transceiver. Also, using KPG-D1/ D1N, the parameters of the following various functions to be used with Individual Call
Acknowledge Request can be configured.
Call Request Tone
0
Call Processing Tone
0
Call Processing Tone Delay Time
0
Call in Progress Tone
0
Note
When "Interrupt CALL" is configured for In-call Busy Channel Lockout, Individual Call Acknowledge Request can be
0
used even when "No" is configured for Busy Channel Lockout (DMR).
Individual Call Acknowledge Request cannot be used while the transceiver is placed in Emergency Mode. A normal
0
Individual Call, which does not require the sending of a message requesting an acknowledgment, can only be used.
For an Individual Call (Individual Call Acknowledge Request), the following functions used for a normal Individual Call
0
are available. (Refer to Making an Individual
Unit ID List
0
Caller ID Display
0
Unit ID Encode Block
0
Configuration using KPG-D1/ D1N
0
Configuring Individual Call Acknowledge Request to be enabled or disabled (
> Personal Features > DMR Conventional > DMR > Individual Call Acknowledge Request)
0
Configuring Busy Channel Lockout (DMR) (
Conventional > DMR)
DMR FUNC (K, F)/Ver 2.20
Call.)
Transceiver Settings > Zone/Channel > Channel Edit > DMR
Transceiver Settings > Personal
CONTENTS INDEX
25