Kenwood NX-5000 Series Function Reference page 69

1 DMR CONVENTIONAL SYSTEM
1.11 Sending and Receiving a Short Message (Short Data Call)
0
PC command
The transceiver will send a Short Message when a PC sends a command to the transceiver communication port specifying
to send a Short Message. To use a PC command, "Data" or "Data + GPS Data Output" needs to be assigned to the
communication port of the transceiver. (Refer to Common FUNC
This section describes how to send a Short Message in Short Message Mode.
Note
For operating in Individual Call Mode or Group Call Mode, refer to the information on the various call types of DMR.
Operating the transceiver
1
Select one of the following operations to place the transceiver in Short Message Mode.
0
Press the Short Message key.
The transceiver enters Short Message Mode. In this case, a Short
Message is addressed to a Base ID.
0
Press the Individual + Short Message key.
Pressing the [F] key after selecting the Unit ID of the target transceiver
causes Short Message Mode to be entered.
0 Press the Group + Short Message key.
Pressing the [F] button after selecting the Group ID of the target
transceiver causes Short Message Mode to be entered.
Or, the transceiver enters Short Message Mode by pressing the Menu key
or using a keypad. In this case, the following operations are identical.
2
Enter a Short Message.
For a Group call, a maximum of 365 characters can be entered, and for an
Individual Call, a maximum of 489 characters can be entered. Refer to
Common FUNC "Entering or Deleting
DMR FUNC (K, F)/Ver 2.20
Available Functions for COM
Characters" for the entry method.
Port.)
Short Message
Message?
Short Message
JV
Se nd
CONTENTS INDEX
A
12 : 34
M
A
B ac k
A
12 : 34
M
A
De let e
52