ABB SmartTouch B/stainless Product Manual page 204

Options:
The parameter is used to specify how many control elements are used.
Type of the control element x:
Options:
The parameter is used to specify the type of control element used.
– Switch: Switching commands are sent with 1 bit (0 or 1), e.g. for switching a switching
actuator. The following supplementary parameter is available:
Value for object x:
Options:
– Roller blind: Allocation of a blind actuator. The following supplementary parameter is
available:
Value for object x:
Options:
– Forced operation: Management systems can access the device directly via KNX. It can
additionally be specified that selection can be carried out manually via buttons (forced
operation). The following supplementary parameter is available:
Value for object x:
Options:
– 1-byte value [0 - 100%]: A value is sent as 1-byte percentage value. The following
supplementary parameter is available:
Value for object x:
Options:
– 1-byte value [0 - 255]: A value is sent as 1-byte value without a sign, e.g. actuating value,
angle or brightness value. The following supplementary parameter is available:
Value for object x:
Options:
Product manual 2CKA001473B5343
KNX control elements and application parameters
1
2
3
4
5
Switch
Roller blind
Forced operation
1-byte value [0-100%]
1-byte value [0-255]
8-bit scene
OFF
ON
"Up/Open"
"Down/Close"
ON, forced operation active
OFF, forced operation active
Deactivate forced operation
Setting option from 0 - 100
Setting option from 0 - 255
Application "Door communication"
│204