Installation Of The Abb Dca Smarttouch 10 - ABB SmartTouch B/stainless Product Manual

Commissioning of the KNX function via ABB DCA SmartTouch 10 (from
9.1.2

Installation of the ABB DCA SmartTouch 10

For the assembly of the control elements, the initial commissioning of the ABB SmartTouch
and for the display of the DCA commissioning tool, a special app must be installed.
This app can then be called up in the ETS via an additional tab (DCA (ABB DCA SmartTouch
10)). For this a licensed version of the ETS Professional Software must be installed on the
target computer for the installation. At least the latest version of the ETS5 is required.
Notice
Also ETS6 can be used.
■
The ETS app can be downloaded via the electronic catalogue (www.busch-
■
jaeger-catalogue.com).
The ETS app can also be downloaded directly via the homepage of the KNX
■
organisation (https://knx.org).
The apps are called up as follows:
■
– Up to including ETS5: on the ETS start page via "App" (bottom right).
– From ETS6: via the ETS settings.
Product manual 2CKA001473B5343
ETS5)
®
│68