ABB SmartTouch B/stainless Product Manual page 44

The initial commissioning of the ABB SmartTouch
specific initial commissioning is available in the system-specific description on commissioning.
1. Select the desired system.
– Observe Chapter 7.1 "Initial commissioning with ABB-free@home
special features during commissioning with free@home.
Notice
If there is more than one System Access Point in a free@home system, the
System Access Point to which a connection is to be established must be
selected manually.
2. Specify the country in which the device is operated.
Notice
The setting is important, since there are countries with local restrictions for
wireless networks.
3. Tap on "Next".
4. Activate WiFi and establish a connection to a network.
– For a manual connection, then enter the network information.
5. Tap on "Next".
6. Specify the time zone and time settings.
7. Tap on "Next".
– The device connects itself with the system. A load screen follows.
Notice
The following parameter setting of the functions is made via the commissioning
tool ABB DCA SmartTouch 10, or alternatively, via the Web-based user interface
of free@home.
Special features
Depending on the selected system, please observe the following special features:
ABB-Welcome IP:
■
– The configuration is taken over fully automatic when the device is taken into operation
via ABB-Welcome IP in combination with ABB-free@home
– Access to MyBuildings must be activated
ABB-Welcome
■
– only 1 operating page in the panel is possible
ABB-Welcome
■
– ABB-Welcome
IP
ABB-free@home
■
Synchronisation of the weather data is possible only via MyBuildings
–
Product manual 2CKA001473B5343
®
:
®
+ ABB-Welcome IP:
®
must be configured first, then follows the configuration of ABB-Welcome
®
Initial commissioning of device
® is described in general in the following. The
®
®
.
" on page 45 for the
│44