System Settings - Via - ABB SmartTouch B/stainless Product Manual

Update via SD card
1. Tap on the "Read SD card" button in the "Firmware update" tab.
– The system then searches for available updates. If there is a new update on the SD
card, this is displayed in the dialogue.
2. Perform the update by tapping on "Install update".
– The successful installation is displayed in the dialogue. If there was a problem during
the update, it can be installed again.
Performing a restart of the panel
1. Tap on the "Restart panel" button in the "Firmware update" tab.
2. Tap on the "Restart panel" button in the dialogue.
– The panel is restarted.
Importing / exporting the backup of the panel
1. Tap on the "Read SD card" button or "Create backup manually" in the "Panel backup" tab.
2. Enter the PIN code.
– The backup file will then be loaded into the panel, or created.
– The panel is restarted.

12.7.11 System settings - Via

From this page information about the WIFI connection, networked systems and licence
requirements can be called up. You can switch between the different system information via the
tabs at the upper edge of the screen.
Also log files can be exported to the SD card.
Product manual 2CKA001473B5343
Operation
│357