System Settings - Display - ABB SmartTouch B/stainless Product Manual

The following areas become available:
Pos. Designation
[1] Display
[2] Sound
[3] Network connections
[4] Time and date
[5] Access authorizations
[6] User settings
[7] Video surveillance
[8] Programming button
[9] Advanced settings
[10] Software update
[11] About
12.7.1

System settings - Display

In the system settings under "Display", general settings such as screen brightness and the
layout can be specified. Also the screen saver can be specified.
Activate display cleaning mode
Product manual 2CKA001473B5343
Description
Setting the brightness of the display via the
slider. Specifying a screensaver.
Specifying the volume for the following sounds:
Click sound
■
Warning sound
■
Fault sound
■
Also a selection of sounds for different types of
messages can be made.
■ If a micro SD card (SDHC) with suitable
sound files is in the device, select a different
sound from the card via the drop-down
menu. The sound files should have format
"mp3". Also wave files can be used.
Notice
The card must remain inserted in the device for
this function!
Adjustment of the network settings. Setup of
access to the Welcome app and the
MyBuildings Portal.
Different time and date settings:
Time
■
Time zone
■
Date
■
Start of week
■
If it was specified in the commissioning
software that the end user can change the PIN
code directly on the device, this page then
becomes visible.
Here the PIN code levels can be specified
■
and adjusted.
Here the following settings can be made:
Language
■
Sensors
■
Door communication
■
Reset options
■
Management of the IP and Welcome cameras
(preview, positioning, etc.).
Here the programming button for the primary
function is added and set.
Here settings can be made and data can be
deleted.
Via this area the software is updated (see
chapter "System settings - Software update" on
page 356).
This page provides general system information.
Operation
│344