Commissioning Of The Knx Function Via Abb Dca Smarttouch 10 (From Ets5); Integration Into The Knx System (Ets); Prerequisites - ABB SmartTouch B/stainless Product Manual

Commissioning of the KNX function via ABB DCA SmartTouch 10 (from
9 Commissioning of the KNX function via ABB DCA
SmartTouch 10 (from ETS5)
Commissioning the ABB SmartTouch
SmartTouch 10.
9.1

Integration into the KNX system (ETS)

Notice
The device meets KNX guidelines and can be used as product of the KNX
system. Detailed expert knowledge for understanding by means of KNX training
is assumed, especially with regard to the commissioning software ETS.
9.1.1

Prerequisites

DCA version
The minimum requirement is the use of the ABB DCA SmartTouch 10.
ETS version
The minimum requirement is the use of ETS from version 5.
SD card
The following SD card types are supported:
Type: Every commercially available SD card is supported
Capacity: 4 - 128 GB
File System: exFAT / FAT32
Notice
It is recommended to use SD cards from ScanDisk, Kingston and Transcend
■
that have been fully tested and checked.
While pictures are being recorded or copied on the card, do not remove the
■
SD card nor restart the panel. Otherwise, pictures may not be displayed.
ABB is not liable for the performance of an SD card.
■
Product manual 2CKA001473B5343
®
via the plug-in ETS5 commissioning tool ABB DCA
ETS5)
│67