Object Type X - ABB SmartTouch B/stainless Product Manual

10.20.6 Object type x

Options:
When actuated or during a sequence, components of a scene can send telegrams via the
associated communication object. Parameter "Object type x" is used to specify the size of the
communication object.
– Switch: Switching commands are sent with 1 bit (0 or 1), e.g. for switching a switching
actuator. The following supplementary parameter is available:
Value for object x:
Options:
– Roller blind: Allocation of a blind actuator. The following supplementary parameter is
available:
Value for object x:
Options:
– Forced operation: Management systems can access the device directly via KNX. It can
additionally be specified that selection can be carried out manually via buttons (forced
operation). The following supplementary parameter is available:
Value for object x:
Options:
Product manual 2CKA001473B5343
KNX control elements and application parameters
Switch
Roller blind
Forced operation
1-byte value [0 - 100%]
1-byte value [0 - 255]
RGB colour
RGBW colour
Colour temperature
8-bit scene
RTC operating mode
Temperature
14-byte text
OFF
ON
Notice
Parameter "Value for object x" can only be set for all options if parameter
"Object x is to be changed" is set on "Yes".
"Up/Open"
"Down/Close"
ON, forced operation active
OFF, forced operation active
Deactivate forced operation
Application "Scene actuator"
│211