Panasonic EBL512 G3 Operating Instructions Manual page 72

FAULT: SSD mismatch, General Control Panel xx
Channel x, CU xx
The SSD (Site Specific Data) downloaded in the General control panel doesn't match the SSD downloaded in the control unit..
A new SSD download (via EBLWin) must be performed in both General control panel and the control unit.
FAULT: Supervised input x expansion board
x, control unit xx
A fault on the supervised input x on the expansion board 4583 with address x, in control unit no. xx.
Check the cables / connections (cut-off or short-circuit).
FAULT: Supervised input x
technical number xxxxxx
A fault on the supervised input x in 4461/4462
A fault on the supervised input x on the board 4464. (Mounted in power supply 4466)
Check the cables / connections (cut-off or short-circuit).
FAULT: Supervised input x,
control unit xx
A fault on the supervised input x in the control unit xx.
Check the cables / connections (cut-off or short-circuit).
FAULT: Supervised output x,
control unit xx
If the output is programmed for sounders (type "Alarm devices"), it is also indicated by LED Fault / Disablements "Alarm devices"
blinking.
If the output is programmed for fire brigade tx (type "Routing equipment"), it is also indicated by LED Fault / Disablements "Fire
brigade tx" blinking.
If the output is programmed for an extinguishing system (type "Extinguishing"), there will be an additional information text close to
the soft key area in the display: Extinguishing wire fault.
Supervised (1-50 kΩ):
x=0 (S0): Short circuit/break on the connected cable/ equipment
x=1 (S1): Short circuit/break on the connected cable/ equipment
x=2 (S2): Short circuit/break on the connected cable/ equipment
x=3 (S3): Short circuit/break on the connected cable/ equipment
Fuse T500mA L 250V
• Calibration not performed via menu H5/A1.
• Connected equipment might be "stolen".
• Resistor(s) missing or not correct value. (1-5 resistors 33 kΩ)
The calibrated value has to be in the range 1 kΩ - 50 kΩ.
72