Disable Or Re-Enable Control Outputs - Panasonic EBL512 G3 Operating Instructions Manual
Hide thumbs
Also See for EBL512 G3:
- Planning instructions (168 pages) ,
- User manual (31 pages) ,
- Information (2 pages)
Table of Contents
Advertisement
EBL512 G3 V. 3.0.X - FIRE ALARM SOLUTIONS OPERATING INSTRUCTIONS
15. DISABLE OR RE-ENABLE CONTROL OUTPUTS
All control outputs programmed as type:
•
Control (general)
•
Ventilation (Fire ventilation)
•
Extinguishing
•
Interlocking
... can via menu H2/B3 be collectively disabled for a specified control unit or all control units. This is indicated by LED Fault / Dis-
ablements "General disablements".
They will remain disabled until they are re-enabled again via menu H2/B3.
See also section
34.8. ACTIVATE / RESET OUTPUTS (H8/S8)
disabled.
See also chapter
35.2. ACTIVATE / DEACTIVATE INTERLOCKING OUTPUT (H9/C2)
ed for an output test, even if it is disabled.
on page 124. An output can be activated for an output test, even if it is
on page 126. An interlocking output can be activat-
33
Advertisement
Table of Contents
