Fault Acknowledge - Panasonic EBL512 G3 Operating Instructions Manual

22. FAULT ACKNOWLEDGE

The LEDs Routing equipment "Fault tx activated" and Fault / Disablements "General fault" are turned on. This is indicating that
output for routing equipment (Fault tx) is activated. (LEDs Fault / Disablements "Alarm devices", "System fault" and/or Fault / Dis-
ablements "Fire brigade tx" might be turned on as well.
Output(s) for routing equipment (Fault tx) is (are) activated.
Output(s) for general fault is (are) activated.
Output(s) for general charge fault might be activated.
One or more fault messages incl. date and time are shown in the control unit display.
If Fault latching is selected in EBLWin, after the time might be shown "/Serviced" = the fault is already serviced / corrected.
Any already Acknowledged fault in the list is indicated by "/Acknowledged".
Example: Fault messages shown in the control unit display:
FAULT: No reply zone: 123 address: 01
technical number 000025
"...alarm text..."
2021-04-03 15:22
FAULT: No reply zone: 123 address: 03
technical number 000027
"...alarm text..."
2021-04-07 09:25
Number of faults in system: 5
Menu
See also chapter
32. FAULT ACKNOWLEDGE (H6)
Menu H6 is a list showing a maximum of 300 faults. This includes not acknowledged faults and/or acknowledged but not serviced /
corrected faults.
• All faults must be individually acknowledged one by one.
• If a fault has been corrected before it has been acknowledged, the text "serviced" is added after the time. It still must be ac-
knowledged.
• When a fault is corrected / serviced and acknowledged, it will disappear from the list (H6).
• When all faults have been acknowledged, output(s) for routing equipment (Fault tx) is (are) reset (i.e. the LED Routing equip-
ment "Fault tx activated" will be turned off).
• As long as there are faults (i.e. not acknowledged faults and/or acknowledged but not corrected faults) the LED Fault / Disable-
ments "General fault" will be lit and general fault (and maybe general charge fault) output(s) are activated.
• Faults, corrected faults and acknowledged faults are shown in the General event log (menu H4/U6).
/Serviced
/Acknowledge
on page 113.
76