Disk Alarm - D-Link DCS-F Series User Manual

Camera User Manual
Parameter
Valid Signal
Alarm Output
Mode
Alarm Time
(ms) (0:
Continuous)
Timing Alarm
Output
Manual
Control
Step 3 Click Apply.
The message "Apply success!" is displayed, and the system saves the settings.
----End

Disk Alarm

Procedure
Step 1 Choose Configuration > Alarm > Disk Alarm.
The Disk Alarm page is displayed, as shown in Figure 9-2.
Issue V1.0 (2023-02-10)
Description
The options are as follows:
Close: An alarm is generated when an
external alarm signal is received.
Open: An alarm is generated when no
external alarm signal is received.
When the device receives I/O alarm signals,
the device sends the alarm information to an
external alarm device in the mode specified
by this parameter. The options include the
switch mode and pulse mode.
NOTE
If the switch mode is used, the alarm frequency
of the device must be the same as that of the
external alarm device.
If the pulse mode is used, the alarm frequency
of the external alarm device can be configured.
Alarm output duration. The value 0 indicates
that the alarm remains valid.
Enable timing alarm output, set the schedule
to time alarm。
NOTE
If there are two alarm outputs, this setting is only
valid for Alarm output 1.
Control the alarm output.
Configure the Alarm Function
Setting
[Setting method]
Select a value from the
drop-down list box.
[Default value]
Close
[Setting method]
Select a value from the
drop-down list box.
[Default value]
Switch Mode
[Setting method]
Enter a value manually.
[Default value]
0
[Value range]
0 to 86400 seconds
[Setting method]
Enable
[Default value]
OFF
N/A
103