Configure And Invoke Tours - D-Link DCS-F Series User Manual

Parameters of PTZ
2. Set the scan ID and name.
3. Click
4. Use arrow keys in the PTZ Control area to set a start point and an end point.
5. Click
Step 2 Invoke a scan.
Select a scan value from the Scan list box, click
A maximum of twelve scans can be configured.

Configure and Invoke Tours

You can configure a tour to allow the camera to repeatedly rotate based the tours. Each tour includes
presets and wait time should be set.
Step 1 Configure a tour.
1. Click Tour.
The Tour Add page is displayed as shown in Figure 2-5.
2. Set the tour ID and name.
3. Select a preset and set the wait time and click
4. Continue to select a preset and set the wait time and click
5. Repeat the step 3 and step 4 to add more presets.
6. Click
Step 2 Invoke a tour.
Select a tour value from the tour list box, click
A maximum of twelve tours can be configured.
16
.
to finish the scan setting.
Tour configuration
to finish the tour setting.
to invoke the scan.
.
.
to invoke the tour.
Issue V 1.1(2021-08-12)
Camera User Manual