D-Link DCS-F Series User Manual page 82

Configure Intelligent Analysis
Parameter
Limit Type
Output
Channel
Audible alarm
Flashlight
Alarm
Alarm Record
SMTP
FTP Upload
Whitelight
Alarm
Step 3 Set a deployment area
Move the cursor to the drawing interface and click to generate a point, move the cursor to draw a line,
and then click to generate another point. This is how a line is generated. In this way, continue to draw
lines to form any shape, and right-click to finish line drawing, as shown in Figure 7-2.
Issue V1.0 (2023-02-10)
Description
Enable to choose the limit type (person or car /
person / car) from type drop-down list.
If you check to set the Output Channel and the
device is connected to an external alarm
indicator, the alarm indicator signals when an
alarm is triggered. Only for Some Models.
Enable, when the alarm happens, it will be play
audio to alarm.
Choose the audible alarm file (set at the
"Configuration > Alarm > Audible Alarm
Output").
Enable to flashlight alarm when it triggers the
alarm, the flashlight will flash. Only for some
models.
Enable the button to enable the alarm record.
Enable the button to enable SMTP sever. More
details please refer to chapter 13.5
Enable the button to enable File Transfer
Protocol. More details please refer to chapter
13.6 .
When the DayNight mode is chosen Night
mode, and the light is IR LED or NONE, this
linkage action is valid.
Enable to whitelight alarm when it triggers the
alarm, the whitelight will be on. Only for Some
Models.
Camera User Manual
Setting
[How to set]
Click the button on.
[Default value]
OFF
[How to set]
Click to select an ID.
[How to set]
Click to enable Audio
Detection Alarm
[Default value]
OFF
[How to set]
Click the button on.
[Default value]
OFF
[How to set]
Click to enable Alarm
Record.
[Default value]
OFF
[How to set]
Click to enable
SMTP.
[Default value]
OFF
[How to set]
Click to enable FTP
Upload.
[Default value]
OFF
[How to set]
Click the button on.
[Default value]
OFF
74