D-Link DCS-F Series User Manual page 86

Configure Intelligent Analysis
Parameter
Limit Type
Output
Channel
Audible Alarm
Flashlight
Alarm
Alarm Record
SMTP
FTP Upload
Whitelight
Alarm
Step 3 Set a deployment area
Drawing a line: Move the cursor to the drawing interface, hold down the left mouse button, and move
the cursor to draw a line. When you release the left mouse button, a single line crossing is generated.
Setting a single line crossing: Click a line (and the trip line turns red) to select the single line crossing
and set its direction as positive, reverse or bidirectional, or delete the selected line. You can also press
and hold left mouse button at the endpoint of a single line crossing and move the mouse to modify the
position and length of this single line crossing. You can right-click to delete the single line crossing, as
shown in Figure 7-5.
Issue V1.0 (2023-02-10)
Description
Enable to choose the limit type (person or car /
person / car) from type drop-down list.
If you check to set the Output Channel and the
device is connected to an external alarm
indicator, the alarm indicator signals when an
alarm is triggered. Only for some models.
Enable, when the alarm happens, it will be play
audio to alarm.
Choose the audible alarm file (set at the
"Configuration > Alarm > Audible Alarm
Output").
Only for some models.
Enable to flashlight alarm when it triggers the
alarm, the flashlight will flash. Only for some
models.
Enable the button to enable the alarm record.
Enable the button to enable SMTP sever.
Details please refer to chapter 10.5.
Enable the button to enable File Transfer
Protocol. Details please refer to chapter 10.6.
When the DayNight mode is chosen Night
mode, and the light is IR LED or NONE, this
linkage action is valid.
Enable to whitelight alarm when it triggers the
alarm, the whitelight will be on. Only for Some
Models.
Camera User Manual
Setting
[How to set]
Click the button on.
[Default value]
OFF
[How to set]
Click to select an ID.
[How to set]
Click the button on.
[Default value]
OFF
[How to set]
Click the button on.
[Default value]
OFF
[How to set]
Click to enable Alarm
Record.
[Default value]
OFF
[How to set]
Click to enable SMTP.
[Default value]
OFF
[How to set]
Click to enable FTP.
[Default value]
OFF
[How to set]
Click the button on.
[Default value]
OFF
78