Table of Contents
Advertisement
Camera User Manual
Parameter
PTZ
PTZ Protocol
PTZ Address
Serial Port
Baud Rate
Data Bits
Stop Bits
Parity Verification
Step 3 Click Apply.
The message "Apply success!" is displayed, and the system saves the settings.
----End
Issue V1.0 (2023-02-10)
PTZ Parameters
Description
Enable this function if the device connects
to an external PTZ.
NOTE
This check box is dimmed for an IP dome
camera.
Protocol used by the external PTZ, such as
PELCO_D and PELCO_P.
Address of the external PTZ.
The default value is COM1.
Baud rate used by the external PTZ. The
value ranges from 300 bit/s to 115200 bit/s.
The default value is 4800 bit/s.
The value must match the setting used by
the external PTZ. It can be set to a value
ranging from 4 to 8. Generally, the value is
8.
N/A
N/A
Configure External Devices
Setting
[Setting method]
Click the button on to
enable PTZ
configuration.
[Setting method]
Select a value from
the drop-down list
box.
NOTE
When external PTZ
parameters are
configured, these
parameters must match
the settings on the
external PTZ.
67
Advertisement
Table of Contents
