Table of Contents
Advertisement
Camera User Manual
Configure Idles
You can enable idle to allow the camera to run the preset, track, scan and tour automatically after the
waiting time (1 minute ~ 240 minutes).
Step 1 Click Idle.
The Idle Add page is displayed as shown in Figure 2-6.
Step 2 Enable the Idle button.
Step 3 Set the idle type and name from list.
Step 4 Set the wait time(1 min ~240 min ).
Step 5 Click
Configure Timer
You can set the PTZ timer to allow the camera to invoke the preset, track, scan and tour automatically in
the setting time and the camera will restore to the operation and location after the end time.
Step 1 Click Timer.
The Set the PTZ Timer page is displayed and click
Figure 2-7.
Step 2 Enable Timer.
Issue V1.0 (2023-02-10)
Idle configuration
to finish the idle setting.
Timer configuration
, the Timer page is displayed as shown in
Parameters of PTZ
17
Advertisement
Table of Contents
