I/O Alarm Linkage (Only For Some Models) - D-Link DCS-F Series User Manual

Configure the Alarm Function
Click the armed icon
unarming time.
Method 1：Click left mouse button to select any time point within 0:00-24:00 from Monday to Sunday.
Method 2：Hold down the left mouse button, drag and release mouse to select the deployment time
within 0:00-24:00 from Monday to Sunday.
Deleting deployment time: Click
same as set deployment time.
NOTE
When you select time by dragging the cursor, the cursor cannot be moved out of the time area. Otherwise, no
time can be selected.
Step 4 Click the button on to enable Alarm Record.
Step 5 Click the button on to enable SMTP.
Step 6 Click the button on to enable FTP Upload.
Step 7 Click Apply.
The message "Apply success!" is displayed, the system saves the settings
----End

I/O Alarm Linkage (Only for Some Models)

Description
Alarm linkage refers to linkage alarm output. When receiving an alarm from the alarm input port, the
camera performs linkage alarm output, and operate based on the linkage policy.
On the I/O Alarm Linkage page, you can perform the following operations:
Enable the I/O alarm function.
Configure the I/O alarm schedule.
Configure the alarm output channel.
Procedure
Step 1 Choose Configuration > Alarm > I/O Alarm Linkage.
The I/O Alarm Linkage page is displayed, as shown in Figure 9-5.
106
to set the arming time. Click the Unarmed icon
to delete the selected deployment time. The methods are
Camera User Manual
to set the
Issue V1.0 (2023-02-10)