Intelligent Monitor Software (Gp-Xaim) (Optional) - Panasonic GP-X Series User Manual

6.3 Intelligent Monitor Software (GP-XAiM) (Optional)

With the optional intelligent monitor software (GP-XAiM), the measurement
data can be easily analyzed or saved at your PC while conditions can be
entered, saved or loaded.
to acquire ready-to-analyze data assuredly.
For details, contact us.
To use the intelligent monitor software (GP-XAiM) correctly
Preparation for operation of GP-XAiM
Before operating GP-XAiM, check the following.
[1] In the case of operation of a network with linked controller
communication units (GP-XCOM)
(1) Set the terminator switch of each GP-XCOM correctly.
(2) Use "Auto" for address assignment of GP-XCOM.
[2] Preparation necessary after startup of GP-XAiM before online
operation is started
(1) Enter the same RS-232C communication settings of the PC as
(2) For details, refer to "help" of GP-XAiM.
To buffer data using GP-XAiM, the data acquisition interval varies
according to the relationship between the data size to be acquired and the
shown below as a measure.
The initial setting of the transmission speed of the controller is 19,200
Loading from controller connected with RS-232C cable
Baud rate
(bps)
19,200
57,600
115.2k
The above values are based on using GP-XAiM Ver.2 or later.
132
Ramco Innovations www.ramcoi.com
If "Auto" is not used, addresses may not be recognized correctly.
those of the controller.
No. of buffered data pieces
5,000 points
8 sec.approx.
4 sec.approx.
3 sec.approx.
10,000 points 50,000 points
16 sec.approx. 1 min. 20 sec. approx.
8 sec. approx. 40 sec. approx.
6 sec. approx. 30 sec. approx.
Phone 800-280-6933 nsales@ramcoi.com