Error Indication List - Panasonic GP-X Series User Manual

7.1 Error Indication List

Error indication
Upper line
136
Ramco Innovations www.ramcoi.com
Alarm
Description of error
output
Lower line
EEPROM
ON
loading error
EEPROM
ON
writing error
Memory switching
ON
error
Broken sensor head
ON
cable
There is a short circuit
in
circuit.
Short circuit
protection functions.
Three-point calibration
is incorrect.
The correction data
ON after
calibration is incorrect.
The following equation
of the upper and lower
limit
true:[(Upper limit value)
- (hysteresis width)] <
[(Lower limit value) +
(hysteresis width)]
The following equation
of the hysteresis width
stands
limit
(hysteresis width)] <
[(Lower limit value) +
(hysteresis width)]
The trigger level
exceeds the setting
range.
The sum of the trigger
level
hysteresis
the setting range.
Display scale error.
This error occurs if the
same
displayed
entered for the first
and second points. Or
a value beyond the
range is entered or the
inclination is too large.
Turn the power off then
data
on again. If the error
persists, initialize settings
(to restore
data
shipment settings) and
enter settings again.
After resetting, initialize
settings and enter setting
again.
Check the wiring and
connect again.
external output
Check the wiring and
connect again.
Perform adjustment again.
three-point
Perform adjustment again.
values stands
Enter correct values.
true:[(Upper
value) -
Enter correct values.
Enter the correct value.
Setting range:
0mm to 110% of F.S.
E n t e r c o r r e c t va l u e s.
S e t t i n g r a n g e :
and trigger
exceeds 0mm to 120% of F.S.
distance or
Enter the correct scale.
value is
Distance setting range:
0mm to 110% of F.S.
Phone 800-280-6933 nsales@ramcoi.com
Resetting key
Remedy
Press and hold
factory
Or enter an external
reset signal.
Press and hold
Or enter an external
reset signal.
Automatic recovery
Automatic recovery
P r e s s
P r e s s
P r e s s
P r e s s
P r e s s
P r e s s
P r e s s
.
.
.
.
.
.
.
.
.