Panasonic GP-X Series User Manual page 67

4) Select the height detection mode.
<Detection state>
5) Set the tolerance judgment value.
6) Press the
7) Supply an external trigger signal at the timing input terminal to hold the
Ramco Innovations www.ramcoi.com
<Application mode>
<BDC detection mode>
<Rotation/eccentricity mode>
<Height detection mode>
Enter the upper and lower limit values for GO judgment in respect to the reference
position (zero point).
・Upper limit value (H-thr): Enter the positive tolerance.
・Lower limit value (L-thr): Enter the negative tolerance.
key to return to the detection state.
For details of the upper/lower limit value entry method, refer to section "3.2
Reference
Upper and Lower Limit Value Settings" on page 48.
・The upper and lower limit values having been entered before the height
detection mode is selected change during mode selection, so that the limit
values must be entered again.
・There is another method for setting the upper and lower limits in respect
POINT
to actual upper and lower limit samples. (Upper and lower limit value entry
through teaching)
detection value at the time and output of judgment. (Sample hold)
Press to select "APPLI".
Negative slope
Press the
Phone 800-280-6933 nsales@ramcoi.com
End of entry
key to return.
61