Panasonic GP-X Series User Manual page 34

Zero Setting
Press and hold the
change the current position of the detected object to the zero (reference) po-
sition while the displayed value and analog voltage output are zeroed.
in the detected object or according to the workpiece positions varying as time
passes.
Press and hold the
setting.
Press and immediately release the
ON/OFF state.
the
If the detected distance exceeds the detection range (maximum detection
distance), zero setting cannot be performed. If zero setting is attempted, an
"Err15/0-Set" error message is displayed with an alarm output.
After pressing and holding down the
error, set the distance again, within the detection range.
・Make sure to check the trigger level (in the case of internal trigger) and the
upper and lower limits after zero setting.
・Zero setting can be performed from an external input terminal. Zero setting
cannot be reset from an external input terminal.
28
Ramco Innovations www.ramcoi.com
key on the panel for longer than two seconds to
key for longer than two seconds, too, to cancel zero
Zero setting ON
key is pressed.
Press and
hold for
longer than
two seconds.
key to check the current zero setting
Zero setting OFF
key for two seconds to remove the
Phone 800-280-6933 nsales@ramcoi.com