Memory Selection; Memory Number Selection - Panasonic GP-X Series User Manual

3.1 Memory Selection

Various conditions are saved in the controller in up to four memories (No. 0 to 3).
The memory number can be switched using a panel key or external terminal.
Reference
Reference

3.1.1 Memory Number Selection

Setting example
Change the memory number from "0" to "2".
<Detection state>
The following items are stored in each memory.
Upper limit value
Lower limit value
Averaging frequency
Measuring mode
Holding measurement
Presence of previous mean
Trigger mode
(Internal) trigger level
(Internal) trigger direction
(Internal) trigger hysteresis
(Internal) trigger delay
*The three-point calibration adjustment data is not copied with the
memory copy function. For the entering method, refer to section "4.2
Three-Point Calibration (Linearity adjustment)" on page 71.
46
Ramco Innovations www.ramcoi.com
For external input/output, refer to section "1.4 External I/O" on page 13.
For the selection of the switching method, refer to section "4.8 Memory
Switching Method Setting" on page 93.
<Memory Number selection>
Item Indication
Press
Item
Sampling time
(Cyclic) trigger time width
Material of object to be detected
Three-point calibration adjustment data
Display scale value
Analog voltage output scale
Output hysteresis
Phone 800-280-6933 nsales@ramcoi.com
to set.
Indication