NEC Electra Elite IPK II System User Manual page 969

Electra Elite IPK II
Programming

10-03-01 ETU Setup (Version 1500 or higher required)
Set various T1 trunk options for compatibility with the local Telco. For ANI/DNIS, the following
settings in Program 10-03 are recommended:
Item 02: Frame Type = 0 (D4)

Item 03: Zero Suppression = 1 (AMI/ZCS)

Item 04: Distance Between ETU and CSU = 0 (0~133')

Item 05: Clock Select = 1 (Internal)

Item 06: DTI No. of Ports= 0 (Auto/24), 1 (4 Ports), 2 (8 Ports), 3 (12 ports), 4 (16 ports), and

5 (20 Ports)

10-09-01 DTMF and Dial Tone Circuit Setup
For ANI/DNIS, reserve at least one DTMF receiver for DTMF reception (entry 0 or 2).
Use the following as a guide when allocating DTMF receivers:
In light traffic sites, allocate one DTMF receiver for every 10 devices that use them.

In heavy traffic sites, allocate one DTMF receiver for every five devices that use them.


10-39-01 Fractional Setup (Version 1500 or higher required)
Enable (1)/Disable (0) T1/PRI fractional function.
(default: 0)

14-01-02 Basic Trunk Data Setup – Transmit Level
14-01-03 Basic Trunk Data Setup – Receive Level
Assign a CODEC Gain Type to each trunk. This sets the amount of gain (amplification) for the
selected trunk.
[default:32 (0dB)]

14-01-07 Basic Trunk Data Setup – Outgoing Calls
For ANI/DNIS, the following additional setting is recommended: Outgoing Calls = 1 (Allowed)

14-02-01 Analog Trunk Data Setup – Signaling Type (DP/DTMF)
For ANI/DNIS, the following additional settings in Program 14-02 are recommended:
Item 1: Signaling Type (DP/DTMF) = 2 (DTMF)

Item 2: Ring Detect Type = 1 (Immediate)

Item 3: Flash Type = 0 (Open Loop Flash)

Item 4: Hooking Type for Timed Flash (0) or Disconnect (1) = 0

Item 5: Dial Tone Detection for Manually Accessed Trunks = 1 (Dial Tone Detection Used)


14-02-02 Analog Trunk Data Setup – Ring Detect Type
Set the trunks for Normal/delayed (0) or Immediate Ringing (1). For T1 loop/ground start trunks,
this option must be set to 1 for the trunks to ring and light correctly.

14-04-01 Behind PBX Setup – Type of Connection
For ANI/DNIS, the following additional setting is recommended: 0 (Stand Alone).
T1 Trunking (with ANI/DNIS Compatibility)
Document Revision 4C
2 - 945