NEC Electra Elite IPK II System User Manual page 681

Hide thumbs Also See for Electra Elite IPK II System:
Table of Contents

Advertisement

Electra Elite IPK II
G.711 -Law – highest bandwidth
G.729 – mid-range bandwidth
G.723 – lowest bandwidth
Each voice call will require at least the bandwidth listed in the following table:
Codec
G.711
-Law
G.729
G.723
Note 1:
Note 2:
Data calls (Modem Data) across the VoIP connection are only supported when G.711 Law
Codec is used.
The IAD(8)-U( ) ETU contains a regular TCP/RTP/IP stack that can handle real time media.
The IAD card, from the network administration perspective, is an end-point on the IP
network.
The IAD(8)-U( ) ETU with IP CCH for NEAXI application loaded uses Common Channel
Interoffice Signaling over IP networks. Currently, this protocol does not allow
communications across networks where Network Address Translation (NAT) is performed.
The audio quality of speech connections depend greatly on the available bandwidth
between the IAD(8)-U( ) ETUs in the data network. As the internet is an uncontrolled data
network compared to an Intranet, it is highly recommended to use this application in
Intranet WAN environment, with known (or controlled and assured) Quality of Service
(QoS).
If any network where the IAD(8)-U( ) ETU is connected uses NAT for connecting the voice
calls (including firewall), It is recommended that you consult your network provider/
administrator and specifically request service for VoIP or real-time media support on your
networks.
A static IP Address is required for each IAD(8)-U( ) ETU in the network.
K-CCIS – IP with IAD
Receive
Transmit
Data
Data Rate
Rate
90 Kbps
90Kbps
34 Kbps
34 Kbps
25 Kbps
25 Kbps
This includes the overheads of VoIP communication, including signaling.
In voice communications, particularly Internet telephony, the mean opinion score (MOS)
provides a numerical measure of the quality of human speech at the destination end of the
circuit. The scheme uses subjective tests (opinionated scores) that are mathematically
averaged to obtain a quantitative indicator of the system performance. The maximum for the
Mean Opinion Score is 5.0.
Time
Packetization
Between
Delay
Packets
20 ms
1.5 ms
20 ms
15.0 ms
30 ms
37.5 ms
Document Revision 4C
Default
Theoretical
Jitter Buffer
Maximum
Delay
MOS
2 datagrams
4.4
(40 ms)
2 datagrams
4.07
(40 ms)
2 datagrams
3.87
(60 ms)
2 - 657

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents