NEC Electra Elite IPK II System User Manual page 288

Document Revision 4C
System Availability
Terminals
All Multiline Terminals
Required Component(s)
None
Related Features
Pulse to Tone Conversion
Programming

15-03-03 Single Line Telephone Basic Data Setup – Terminal Type
Enter 1 for this option to allow a single line port to receive DTMF tones after the initial call setup.
Enter 0 to have the port ignore DTMF tones after the initial call setup. For Voice Mail, always
enter 1 (e.g., receive DTMF tones).

20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.

20-13-13 Class of Service Options (Supplementary Service) – Continued Dialing (DTMF) Signal on
ICM Call
Enable (1)/Disable (0) an extension user ability to use Continued Dialing for Intercom calls to
2500 type devices.

21-04-01 Toll Restriction Class for Extensions
Assign a Toll Restriction Class (1~15) to an extension.

21-05-04 Toll Restriction Class – Maximum Number of Digits Table Assignment
Assign a Maximum Number of Digits Table to each Toll Restriction Class.

21-06-03 Toll Restriction Table Data Setup – Maximum Number of Digits Table Assignment
Set the Maximum Number of digits dialed for each table.
2 - 264
Electra Elite IPK II
Continued Dialing