NEC Electra Elite IPK II System User Manual page 622

Document Revision 4C
When the voice mail places a call on hold, it uses Group Hold. Any line appearances for the

trunk shows the hold flash rate, however, users cannot pick up these calls (a busy signal is
heard).
Updating the system time also updates the In-Mail time.

Both 2- and 4-port In-Mail systems use eight station ports.

VRS Features and In-Mail do not work at the same system.

DSPII-U10 Unithas 32 resources which are used for DT/DTMF/Caller ID receiver or Caller

ID sender. However, when using In-Mail they do not work.
In-Mail and VMS/FMS/VMP/CTI/CTP cannot be used at the same time in the same system.

The displayed message count for New and Saved messages does not update until the

mailbox user hangs up and calls back into the In-Mail.
In-Mail and Analog Voice Mail cannot be used at the same time in the same system.

In-Mail does not support Elite IPKII Centralized Voice Mail.

When transferring a caller to a mailbox the caller hears the personal greeting from the time

the transfer is completed, not from the beginning.
KSU must be licensed for ACD and In-Mail for the ACD Delay Announcement feature to

work.
Master Mailboxes used for ACD Delay Announcements cannot be used for other voice mail

features.
In-Mail ACD Delay Announcement feature requires KSU software 2.00 or higher.

The first port of In-Mail must start with one of the following ports: 1, 5, 9, 12, 16, .....237,

241, 245, 249, and will use the first port assigned + the next three consecutive ports.
Program 41-08-03: ACD Overflow Options – Delay Announcement Source Type is not

supported in Version 1600.
Program 41-19-01~Program 41-19-08: Voice Mail Delay Announcement, is not supported

in Version 1600.
Default Setting
Disabled
2 - 598
Electra Elite IPK II
IPK II In-Mail