NEC Electra Elite IPK II System User Manual page 224

Document Revision 4C

21-01-15 System Options for Outgoing Calls – Outgoing Disable on Incoming Line (Toll
Restriction)
Enable (1)/Disable (0) the Outgoing Disable on Incoming Line feature.

21-01-16 System Options for Outgoing Calls – Supervise Dial Detection Timer
With the Outgoing Disable on Incoming Line feature, if dial tone is not detected after the
extension answers an incoming line, the system determines the call is unable to complete and
releases the DTMF receiver (0~64800 seconds).

21-01-17 System Options for Outgoing Calls – Restriction Digit in Outgoing Disable on Incoming
Line
With the Outgoing Disable on Incoming Line feature, determine the number of digits (0~9) to be
dialed before the call should be disconnected.

21-02-01 Trunk Group Routing for Extensions
Assign Program 14-06 routes to extensions. (Trunk Group Routes: 1~100)

21-15-01 Individual Trunk Group Routing for Extensions
Designate the trunk route accessed when a user dials the Alternate Trunk Route Access Code.
Refer to Trunk Group Routing to set up outbound routing. (Trunk Group Routes: 1~100)

24-02-07 System Options for Transfer – Trunk-to-Trunk Transfer Release Warning Tone
This timer starts when a trunk begins talking with another trunk (e.g., Trunk-to-Trunk Transfer,
outgoing from trunk, Tandem Trunking) (0~64800 seconds). Assign the time before a
Trunk -to -Trunk call is disconnected.

82-08-01 Sidetone Volume Setup
Adjust the multiline terminal side tone volume. There are two levels, based on whether the
connected trunk is a digital trunk or analog trunk.
Operation
To place a call over a trunk group:
1. Go off-hook.
2. Dial 704.
3. Dial trunk group number (001~100).
4. Dial the number.
- OR -
1. At the multiline terminal, press the trunk group key (PRG 15-07-01 or SC 751:
2. Dial the number.
2 - 200
Electra Elite IPK II
02 + group).

Central Office Calls, Placing