NEC Electra Elite IPK II System User Manual page 840

Document Revision 4C
If the feature key is not listed below, the LCD shows ALL-BLANK. (PRG 15-07-01 Line

Key Assign).
Function
Number
00
01
02
03
04
05
07
10
11
12
13
14
15
If a key is programmed as a DSS/One-Touch key for a station that is set for Call Forward All

Calls or Do Not Disturb, the DSS/One-Touch key flashes. If a station is busy, the DSS/
One-Touch for that station does not light solid, even if Call Forward All Calls or DND is set.
 Refer to the Electra Elite IPK II Programming Manual for a complete list of Function
Numbers.
One-Touch keys programmed for Park Hold Service Code cannot be used to park calls

without first using Hold or Transfer.
Pauses can be entered in the dial string of a DSS/One Touch button. The pause is entered

as P in the dial string and causes the system to wait three seconds before sending the rest
of the digits that follow the P (pause). Multiple pauses can be entered.
The @ symbol can be entered in the dial string of a DSS/One Touch button. The @ only

applies to ISDN and Intercom calls. When using @, the system waits for the destination to
answer (answer supervision), and then sends the rest of the digits.
Entering a P (pause) in a DSS/One Touch dial string can be used for CO calls, Intercom

calls, or after @ for ISDN calls.
Default Setting
The first eight keys on a telephone are line keys (e.g., key 1 = line 001). The remaining keys are
unassigned.
2 - 816
Function
None
DSS/One-Touch
Microphone Key (ON/OFF)
DND Key
BGM (ON/OFF)
Headset
Conference Key
Call Forward – Immediate
Call Forward – Busy
Call Forward – No Answer
Call Forward – Busy/No Answer
Call Forward – Both Ring
Follow Me
Display
[All Blank]
DSS (xxxxxxxx xxxxxxxx = Extension Number
MIC
DND
BGM
HSET
CONF
CFA
CFB
CFNA
CFBNA
CFBOTH
FLWME
Programmable Function Keys
Electra Elite IPK II