NEC Electra Elite IPK II System User Manual page 576

Document Revision 4C
Example Configuration 3 – Static IP Addressing, Routed LAN:
This example shows System IP Phones connected to an Elite IPK II over a Wide Area Network (WAN)
with static addressing. This is a typical scenario – a small branch office connecting to an Elite IPK II at
the main office.
IPK II CPU:
VoIP MG16:
Subnet Mask:
Default Gateway: 192.168.1.254
IP Phone 1/100
192.168.2.200
Programming – IPK II CPUII
1. 10-12-01 CPUII Network Setup – IP Address = 192.168.1.20
2. 10-12-02 CPUII Network Setup – Subnet Mask = 255.255.255.0
3. 10-12-03 CPUII Network Setup – Default Gateway = 192.168.1.254
Programming – VoIP MG16
1. 84-05-01 VoIP MG16 IP Address Setup (Slot No.) = 192.168.1.21
Programming – System IP Phones
1. DHCP Mode – Disabled
2 - 552
IPK II CPUII
VoIP MG16
192.168.1.20
192.168.1.21
255.255.255.0
IP Phone 1/101
192.168.2.201
Figure 2-13 Example – Static IP Addressing, Routed WAN
Electra Elite IPK II
Switch/Hub
192.168.1.254
192.168.2.254
Switch/Hub
IP Station (MEGACO) – MG 16
Router
WAN
(Leased line,
Frame Relay,
etc.)
Router