NEC Electra Elite IPK II System User Manual page 115

Electra Elite IPK II

44-02-03 Dial Analysis Table for ARS/F-Route Access – Additional Data
If a Service Type is selected in PRG 44-02-02, set the additional data, if required, for the
Pre-Transaction Table for selecting ARS/F-Route (24 digits max: 1~9, 0
card/don't care digit, press Line Key 1 to enter @.

44-02-04 Dial Analysis Table for ARS/F-Route Access – Dial Tone Simulation
Determine if the Dial Tone Simulation is on (1) or off (0) for the Pre-Transaction Table for
selecting ARS/F-Route. If enabled, this option sends dial tone to the calling party once routing is
determined. This may be required if the central office at the destination does not send dial tone.

44-03-01 Dial Analysis Extension Table – Dial
Set the Dial digits (24 digits max: 1~9, 0
Table. When Program 44-02-02 is set to type 3, this program sets the dial extension analysis
table. These tables are used when the analyzed digits must be more than eight digits. To enter a
wild card/don't care digit, press Line Key 1 to enter @.

44-03-02 Dial Analysis Extension Table – ARS/F-Route Select Table Number (1~250)
When dialed digits match the setting in Program 44-03-01, select the ARS/R-Route table
number (0~500) to be used for the Dial Extension Analysis Table.

44-03-03 Dial Analysis Extension Table – ARS/F-Route Select Table Number (251)
If the received digits are not identified in tables 1~250, the F-Route selection table number
(0~500) defined in table 251 is used.

44-03-04 Dial Analysis Extension Table – Next Table Area Number (252)
If the received digits do not match the digits set in tables 1~250, table number 252 is used refer
to the next Extension Table Area (1~4) to be searched.

44-04-01 ARS/F-Route Selection for Time Schedule
Assign each ARS/F-Route Selection number (1~500) to an ARS/F-Route table number for each
ARS/F-Route time mode. There are eight time modes for ARS/F-Route Access.

44-05-01 ARS/F-Route Table – Trunk Group Number
For each ARS/F-Route table (1~500) assign a priority number (1~4) and enter the trunk number
to be used.
0 = No Setting
101~150 = Networking
255 = Extension Call

44-05-02 ARS/F-Route Table – Delete Digits
For each ARS/F-Route table (1~500) assign a priority number (1~4). Enter the number of digits
to be deleted (0~255) from the dialed number.

44-05-03 ARS/F-Route Table – Additional Dial Number Table
For each ARS/F-Route table (1~500) assign a priority number (1~4). Enter the table number
(defined in PRG 44-06) for additional digits to be dialed (0~1000).
Automatic Route Selection
#, @) to be used for the Dial Extension Analysis

Document Revision 4C
#, @). To enter a wild

2 - 91