NEC Electra Elite IPK II System User Manual page 696

Document Revision 4C
Centralized E911 – K-CCIS is supported.

When Centralized E911 – K-CCIS is not used, each Electra Elite IPK II system in a K-CCIS

network must have at least one trunk for Emergency 911 calls.
Using a NEAX-to-Electra Elite IPK II network, the PBX must supply centralized voice mail.

Multiline terminals must have an available Call Appearance (CAP) key to originate or

answer a K-CCIS trunk call.
Direct access of K-CCIS voice or data channels using Line keys or Specified Line Seizure

access codes is prohibited.
The Recall key or Drop key does not function on K-CCIS calls. When either key is pressed,

operation is ignored, and the call continues.
Trunk queuing is prohibited on a K-CCIS trunk route.

Routing an incoming DID call directly across a K-CCIS link (Direct Inward Dialing

is supported only when a Closed Numbering Plan using F-Routes is used.
This feature is not supported by the TLI(2)-U( ) Analog Line interface.

Only one CCH(4)-U( ) ETU can be assigned per system.

Extension numbers cannot start with 0 or 9.

Internal Calls, transferred calls, and K-CCIS calls do not provide Caller ID to single line

telephones.
Caller ID Call Return feature is not supported with K-CCIS calls.

Call Park Searching is supported only in the local system.

With Version 1600 or higher, a remote K-CCIS user can call, or transfer a call directly to

an ACD Pilot number. However, an incoming K-CCIS call to the ACD Pilot number does
NOT provide a Link Reconnect.
When the system searches the Dial Extension Analyze Table (PRG 11-20-01), the system

uses prefix searching, giving the lower table number the higher priority. For example, the
user programs 211 in table 1 and 2113 in table 2, then dials 2113, the system selects table
1.
Program 11-01-01 9: System Numbering – Dial Extension Analyze is not supported in

Version 1600.
Program 11-20-01: Dial Extension Analyze Table – Dial and Program 11-20-02: Dial

Extension Analyze Table – Type of Dials are not supported in Version 1600.
Default Setting
Not installed
2 - 672
Electra Elite IPK II
K-CCIS)
-
K-CCIS – T1