NEC Electra Elite IPK II System User Manual page 983

Electra Elite IPK II

20-06-01 Class of Service for Extensions
Assign a Class of Service (1~15) to an extension.

20-07-11 Class of Service Options (Administrator Level) – Forced Trunk Disconnect (analog trunk
only)
Enter 1 to enable Forced Trunk Disconnect. This allows the extension to disconnect an
Unsupervised Conference in progress (initially set up using Method B).
[default: 0 (COS 1~14); 1 (COS 15)]

20-11-11 Class of Service Options (Hold/Transfer Service) – Auto On-Hook Transfer
Disable (0)/Enable (1) an extension user ability to transfer when the user hangs up.
(default: 0)

20-11-14 Class of Service Options (Hold/Transfer Service) – Trunk-to-Trunk Transfer Restriction
Disable (0) the Trunk-to-Trunk Transfer Restriction option.
(default: 0)

20-11-21 Class of Service Options (Hold/Transfer Service) – Restriction for Tandem Trunking on
Hang Up
Allow (0) an extension user to set up a tandem call automatically when they hang up.
(default: 0)

24-02-07 System Options for Transfer – Trunk-to-Trunk Transfer Release Warning Tone
This timer (0~64800 seconds). starts when a trunk begins talking with another trunk (for
example: Trunk-to-Trunk Transfer, outgoing from trunk, Tandem Trunking)
(default: 1800)

24-02-10 System Options for Transfer – Disconnect Trunk-to-Trunk
This timer (0~64800 seconds). starts after the Trunk-to-Trunk warning tone is heard.

25-07-07 System Timers for VRS/DISA – Long Conversation Warning Tone Time
Determine the time a DISA caller or any trunk-to-trunk (such as Tandem Trunking) conversation
can talk before the Long Conversation tone is heard (0~64800 seconds).
(default: 3600)

25-07-08 System Timers for VRS/DISA – Long Conversation Disconnect
This timer (0~64800 seconds). determines the time the system waits before disconnecting a a
DISA or any trunk-to-trunk (such as Tandem Trunking) call after the Long Conversation tone is
heard.
(default: 10)
Tandem Trunking Method D – Tandem Trunking to Speed Dial Number

11-10-06 Service Code Setup (for System Administrator) – Setting the Automatic Transfer for Each
Trunk Line
If the default service code (733) for enabling Automatic Tandem Trunking feature is not
acceptable, change the code as required.

11-10-07 Service Code Setup (for System Administrator) – Canceling the Automatic Transfer for
Each Trunk Line
If the default service code (734) for canceling Automatic Tandem Trunking feature is not
acceptable, change the code as required.
Tandem Trunking (Unsupervised Conference)
Document Revision 4C
2 - 959