NEC Electra Elite IPK II System User Manual page 930

Document Revision 4C
To dial a Group Speed Dialing number:
1. Go off-hook.
2. Press Redial.
- OR -
3. Press the Group Speed Dialing key (PRG 15-07-01 or SC 751: 28).
To preselect, press a line key in step 1 (instead of Speaker) before pressing Redial or Speed Dialing key.

4. Dial the Group Speed Dialing code.
The stored number dials out.

Unless you preselect, Trunk Group Routing selects the trunk for the call.

If you have a DSS Console, you may be able to press a DSS Console key to chain to a stored number.

To check your stored Speed Dialing numbers (display telephone only):
1. Press the Help key.
2. For System Speed Dialing, press Redial.
Dial the Speed Dialing Code (e.g., common code 001).
If the entire stored number is too long for your telephone's display, press

- OR -
For Group Speed Dialing, press the Group Speed Dialing key.
- OR -
For System Speed Dialing key, press the System Speed Dialing key.
3. Press the Exit key.
To display additional numbers, repeat from step 1.

To store a Station Speed Dialing number (display telephones only):
1. Press Speaker.
2. Dial 755.
3. Dial the Station Speed Dial buffer number to be programmed (0~9).
1 = Station Speed Dial buffer 1
2 = Station Speed Dial buffer 2
" " "
0 = Station Speed Dial buffer 10
4. Dial the telephone number you want to store (up to 24 digits).
Valid entries are 0~9, # and

5. Press Hold.
2 - 906
" " "
. To enter a pause, press MIC. To store a Flash, press Recall.

Electra Elite IPK II
to see the rest of the number.

Speed Dial – System/Group/Station