NEC Electra Elite IPK II System User Manual page 740

Hide thumbs Also See for Electra Elite IPK II System:
Table of Contents

Advertisement

Document Revision 4C
Required Component(s)
CNF(8)-U( ) ETU
Related Features
None
Programming
10-09-01
DTMF and Dial Tone Circuit Setup
Assign at least one circuit for DTMF reception (type 0 or 1). Use the following as a guide when
allocating DTMF receivers:
In light traffic sites, allocate one DTMF receiver for every 10 devices that use them.
In heavy traffic sites, allocate one DTMF receiver for every five devices that use them.
11-07-01
Department Group Pilot Numbers – Dial
Assign a Department Group pilot number for the CNF(8)-U ETU (eight digits max). The
extensions are assigned to the group in Program 16-02-01.
15-03-01
Single Line Telephone Basic Data Setup – SLT Signaling Type
For each SLT extension, this option must be set to 0.
15-03-03
Single Line Telephone Basic Data Setup – Terminal Type
Set all SLIU ports used for Conference as type 1 to allow the SLT port to receive DTMF tones
after the initial call setup.
16-02-01
Department Group Assignment for Extensions
Put all the CNF(8)-U ETU extensions in a unique Department Group (do not use Department
Group 1). No other extensions should be in this group. This allows DILs to Voice Mail to ring
other Voice Mail extensions when the DILs assigned port is busy. Only one Voice Mail group is
allowed per system. Be sure to set up the Department Group in order. (For example, the first
extension should be order 1, the second order 2, etc.)
20-13-13
Class of Service Options (Supplementary Service) – Continued Dialing (DTMF) Signal on
ICM Call
Enable Continued Dialing (1) for all extensions that dial the Conference ports.
22-02-01
Incoming Call Trunk Setup
Assign Service Type 4 to each trunk you want to ring into the CNF(8)-U ETU as a Direct Inward
Line (DIL).
22-07-01
DIL Assignment
Assign the master/pilot number of the Conference group from Program 11-07-01 as the DIL
destination. If all Conference ports are in the same unique Extension (Department) Group (see
Program 16-02 above), the DIL rings another Conference port if its assigned port is busy.
2 - 716
Electra Elite IPK II
Multiline Conference Bridge

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents