Installing The Msr Utility For Windows - Epson MR Series Technical Reference Manual

TBMOUSE Command Line
TBMOUSE mode
Mode:1
If the screen is touched, the mouse cursor moves to the place that was touched and the left
mouse button is pressed. After that, the finger can be slid across the screen with the left
button held down. The mouse button is released if the finger is lifted from the screen.
Mode:2
If the screen is touched, the mouse cursor moves to the place that was touched, but the left
mouse button is not pressed. Then you can slide your finger across the screen without the
left button being pressed. If the finger's motion is stopped for approximately 0.5 seconds, the
left mouse button is pressed. At this time, a short warning tone sounds once. Once the left
button is pressed, the finger can be slid across the screen with the button pressed. The mouse
button is released when the finger is lifted from the screen.
Mode:3
Mode 3 resembles Mode 2, but a double click is enabled. Once the finger's motion is stopped,
then, while the mouse button is pressed, the finger is quickly separated from the screen and
then immediately brought in contact with the screen again. At this time, a warning tone
sounds once, and the button is immediately pressed again in the same position it was in the
first time it was pressed.
Mode:4
After the finger is quickly lifted from the screen, touching the screen again causes the mouse
button to be pressed.
To display the parameter details, enter the following:
TTDOS /? Enter
TBMOUSE /? Enter

Installing the MSR Utility for Windows

This is installed by the exclusive installation program.
1. Insert the Driver CD-ROM for the IM-800 in the CD-ROM drive. Start Common\Msrcfg\
Win\Disk1\SETUP.EXE.
2. The Setup Wizard starts and the Welcome dialog box is displayed. Click Next.
3. The Choose Destination Location dialog box is displayed. Specify the directory where the
program is to be installed and click Next. C:\Program Files\MSR Config is specified as the
default.
4. Installing is completed, and the Setup dialog box is displayed. Click Finish.
4-50 OS and Drivers Rev. I