Removing The Compornents; Riser Frame - Epson MR Series Technical Reference Manual

3. If it is necessary to remove the IM-800 front case assembly (usually it is not necessary to
remove it), remove the 5 screws (S11) shown below and remove the IM-800 front case
assembly.
screw (S11)
To install, reverse the removal procedure.

Removing the Compornents

Riser Frame

1. Remove the IM-800 upper case. (See page 9-42.)
2. Remove the screw (S13) indicated below.
riser frame
COM port circuit board
screw (S13)
3. Remove the P2 cable and COM cable. Then lift the riser frame out of the IM-800.
Rev. I
MR Series Technical Reference Manual
screw (S11)
IM-800 front case assembly
Disassembly and Assembly 9-43
COM cable
P2 cable