System Fan - Epson MR Series Technical Reference Manual

System Fan

1. Remove the IM-800 upper case. (See page 9-42.)
2. Remove the CD/FDD bracket. (See page 9-49.)
3. Disconnect the system fan cable from the connector indicated below.
system fan cable
4. Remove the two screws (1015) securing the system fan to the frame.
CAUTION:
When you remove or install the system fan, be sure to press the top of the system
fan as indicated by the arrow while you remove or insert the screws. Otherwise you
may bend the frame. And confirm the direction of installing the system fan. (See
the illustration below.)
Also, do not tighten the screws too tightly or the unit may be damaged. (The
maximum torque is 9 kgf • cm.)
5. Remove the system fan from the frame.
To install, reverse the removal procedure.
Rev. I
MR Series Technical Reference Manual
screws (1015)
Disassembly and Assembly 9-61