Removing The Touch Panel Assembly - Epson MR Series Technical Reference Manual

Removing the Touch Panel Assembly

Follow the steps below to disassemble the touch panel assembly (1056).
1. Remove the rear case. (See page 9-11.)
2. Remove the front case from the front panel unit. (See page 9-13.)
3. Remove the rear panel. (See page 9-13.)
4. Remove the LCD circuit board. (See page 9-15.)
5. Disconnect the touch panel cable from the cable for the circuit board, as shown below, by
releasing the patch, and remove the touch panel cable.
cable for the circuit board
Note:
Be careful not to get any foreign material between the LCD and the touch panel.
9-18 Disassembly and Assembly
patch
touch panel cable
locked
cable connection
released
Rev. I