Epson MR Series Technical Reference Manual page 60

13. The image data exchange dialog will appear. Insert the Windows 2000 CD-ROM 2 of 2 in the
CD-ROM drive; then press the OK button.
14. When the prompt below is displayed on the screen, OS recovery work is complete.
X:\>_
15. Eject the "Windows 2000 CD-ROM" from the CD-ROM drive.
16. Reboot and start the BIOS setup utility.
17. Return the First Boot Device in the Advanced BIOS features setup menu to the "Floppy".
18. On the main menu, select "Save & Exit Setup" and press the Enter key. The following dialog
box appears.
SAVE to CMOS and EXIT (Y/N) ?
19. Press [Y] and [Enter]. The system will restart.
20. Make sure the OS restarts. When using Windows, cancel work after the setup screen and
end Windows.
21. If a CD-ROM drive unit is attached in step 2., power off and detach the CD-ROM drive.
Limitation
❏ If you are starting from a hard disk, recovery cannot be performed. Be sure to perform
recovery from the CD-ROM.
4-10 OS and Drivers Rev. I