Epson MR Series Technical Reference Manual page 212

POST messages (Continued)
Message
MEMORY ADDRESS ERROR
AT ...
MEMORY PARITY ERROR AT
...
MEMORY VERIFY ERROR AT
...
MEMORY TEST FAIL
MANUFACTURING POST
LOOP
PRESS A KEY TO REBOOT
PRESS F1 TO DISABLE NMI,
F2 TO REBOOT
SYSTEM HALTED, (CTRL-ALT-
DEL) TO REBOOT ...
8-22 Troubleshooting
Description
If an address error occurs during a memory test, that address is displayed.
This error may be caused by a malfunction of the memory (DIMM) or the main board
(including the memory controller). Try replacing these parts in turn to see if this solves the
problem.
If the memory has not been installed, this is indicated by an error beep at the early POST
stage.
If a data parity error occurs during a memory test, that address is displayed.
This error may be caused by a malfunction of the memory (DIMM) or the main board
(including the memory controller). Try replacing these parts in turn to see if this solves the
problem.
If the memory has not been installed, This is indicated by an error beep at the early POST
stage.
If a data verify error occurs during a memory test, that address is displayed.
This error may be caused by a malfunction of the memory (DIMM) or the main board
(including the memory controller). Try replacing these parts in turn to see if this solves the
problem.
If the memory has not been installed, This is indicated by an error beep at the early POST
stage.
This error is displayed when an unexpected memory error other than above occurs
during a memory test.
This error may be caused by a malfunction of the memory (DIMM) or the main board
(including the memory controller). Try replacing these parts in turn to see if this solves the
problem.
If no memory has been installed, this is indicated by an error beep in the early POST
stage.
This message is displayed when POST processing cannot be completed for some reason
(most likely due to errors related to the keyboard).
If no errors were found in the keyboard, hard disk, and floppy disk drive, try replacing the
main board.
This message is displayed when an error that can be fixed by rebooting by a method
other than software reset (CTRL+ALT+DEL) is found.
Press a key to reboot the system.
If this error occurs frequently, there may be a malfunction of the main board or problems
in the system configuration. Try replacing the main board or check to see if there are any
problems in the system configuration.
This message is displayed when a Non-Maskable Interrupt (NMI) occurs during POST.
Press F1 to clear the NMI and then continue with POST.
Press F2 to reboot.
If this error occurs frequently, there may be a malfunction of the main board or problems
in the system configuration. Try replacing the main board or check to see if there are any
problems in the system configuration.
This message is displayed when an error that can be fixed only by rebooting using
software reset (CTRL+ALT+DEL) is found.
Reboot the BIOS by using the software reset (CTRL+ALT+DEL).
If this error occurs frequently, there may be a malfunction of the main board or problems
in the system configuration. Try replacing the main board to see if this solves the problem.
Rev. I